Impeller Diameter  Impeller R.P.M. (note1) Horsepower Required (note2) Tank Dia. In Inches (note3) Capacity In Gallons (note2) 2"  9500 1 5" to 8" 2 3"  6400 1 7" to 12" 5 4"  4800 2 10" to 16" 10 5"  3800 2 12" to 20" 30 6"  3200 2-5 15" to 24" 50 8"  2400 5-10 20" to 32" 100 10"  1900 10 25" to 40" 150 12"  1600 15-20 30" to 48" 250 14"  1400 20-30 35" to 56" 450 16"  1200 30-50 40" to 64" 650 18"  1100 50-75 45" to 72" 850 20"  950 75-100 50" to 80" 1200 22"  870 100-125 55" to 88" 2000 24"  795 125-150 60" to 96" 2500 26"  735 150-200 65" to 104" 3000 28"  680 250-300 70" to 112" 3500 30"  635 300 75" to 120" 4000 32"  600 300 80" to 128" 4500 34"  560 300 85" to 136" 5000 Note 1.    Impeller RPM is calculated by using 5,000 Feet per minute peripheral speed. (speed of tabs)                                        Impeller RPM=      19,000                                                                       Impeller Dia.  Note 2.    Horsepower required and capacity are approximate figures that are obtained by using he following principal:                    One HP per ten gallons at 5,000 cps using a tank with a diameter equal to batch height. Note 3.    Tank diameters are based on a minimum of 2.5 times impeller diameter to a maximum of 4 times impeller diameter.                   Viscosity and material characteristics will affect all of the above figures but they may be used as a starting point for                   proper impeller selection. Note 4.    All impeller blades are 304 stainless steel unless specified otherwise.  Center holes are placed in blades per customer                   request.  Any Impeller Blade can be Tungston Carbide Coated to add Strength and Durability. Note 5.    To see a picture of are High Speed Shear Blade Click HERE.                                   To see a picture of are Pumper Blade Click HERE.     | Home | Dispersers | Multi-Shaft Mixers | Full Systems | Controls | Contacts |